Tattoo FX – Application Video
In this video we demonstrate the basic application of our tattoo transfer sheets.
The instructions are aimed at professional users and explain the correct procedure from skin preparation to final fixation.
In addition to the video, you will find a written step-by-step guide below.
Tattoo FX – Processing Instructions
1. Preparation
Cut out the motif neatly
Remove protective film
Cleanse skin thoroughly and without oil (e.g. with alcohol)
Apply tattoo only to hairless skin
2. Applying the tattoo
Place the tattoo with the design side facing the skin.
Moisten evenly and thoroughly with water
Press the tattoo firmly and do not move it during this time.
3. Remove backing paper
After approximately 30 seconds, carefully peel off the backing paper.
Do not rub or press the tattoo down again.
4. Drying & Fixing
Allow the tattoo to dry completely.
Then cover the tattoo with a sealer.
(we recommend Bluebird Matt Sealer)If the shine is too strong, use a suitable matting gel or matt sealer.
5. Durability & Care
Do not rub the tattoo vigorously or subject it to mechanical stress.
Do not use oil-based products directly on the tattoo.
Gentle showering is possible, no scrubbing.
6. Remove
A suitable remover is required for removal.
(e.g. Pros-Aide Remover)Carefully loosen the tattoo, do not pull it off forcefully.
Notice
The tattoo transfers are designed for professional use.
For sensitive or allergy-prone skin, we recommend testing the compatibility on a small area of skin beforehand.
Safety instructions
The transfers are intended for external use only.
Apply only to healthy, unbroken skin.
Do not use on irritated, inflamed or broken skin.
For sensitive or allergic skin, it is recommended to perform a compatibility test beforehand.
to carry out the procedure or to refrain from using it.
Avoid contact with eyes, mouth and mucous membranes.
If skin reactions occur, discontinue use immediately and remove the tattoo.
